For many people, there is a certain level of peace that comes from fixing things independently. This can be assembling:
- Furniture
- Installing new lights in the living room
- Repairing dents in your car and many others
It seems to be an innate human desire to feel competent at fixing something solely. But does DIY dent repair work? This article will help you figure out whether or not DIY dent repair can work for your needs!
What is Dent Repair?
Dent repair is a process in which an electric current heats metal until it becomes pliable, and then the dent can be removed. You can do this yourself with some simple tools, and you can save money as well.
However, dents are not always the same and can range from a simple dent to dents requiring bending metal. Some people might think it’s safer for them or someone else if they leave a dent rather than try to fix it themselves. But this is more dangerous because of how brittle steel becomes after being heated up with electricity.
Can You Do It Yourself?
The short answer is no. Auto bodywork and general dent repair require the same skills, equipment, and knowledge as seen in auto collision repair center. In other words, if you don’t have experience in these areas, you shouldn’t try to fix your car’s dents yourself because it could make them worse or cause further damage to adjacent metal work such as doors or windows.
Many people don’t know that there are some do-it-yourself dent removal methods out there that can get rid of minor dings with minimal effort. Some of these methods include using an air compressor or hairdryer, a plunger with hot water and dish soap, rubbing ice on it until it’s frozen, then hammering, or even banging your head against the dent as hard as you can.
It is important to note that all of these techniques are for minor dents only. If your dent is larger in size than about one inch deep, do not try any DIY method because they will most likely worsen big problems!
What is the Process of Dent Removal?
Often, removing a dent is as easy as rubbing it out. All you need to do is place the object that’s dented on top of something hard and flat – like steel wool or a credit card – and rub in small circles for about ten minutes until all traces of the indentation disappear.
If this doesn’t work, you may need to move on to the next step and use a plunger. This typically gets done if the dent is in your car’s metal body, like near a wheel well or undercarriage panel. All you have to do is place the rubber suction cup of the plunger over where there’s a dent, then pump it up and down until the dent pops out.
This question can be difficult to answer. DIY dent repair kits are certainly easier than going through a body shop, but they also have their own set of limitations and drawbacks that may not make them worth the effort in some cases.