4 Plumbing DIY Fixes You Should Learn

Nothing is more inconvenient than having a little plumbing problem in your home and not knowing what to do about it. It’s possible that you’ll have to wait for your plumber to handle it. However, if you are unlucky, the plumber may be ill or unavailable, leaving you stranded! Even if they were accessible, you might not have the money at the time to hire one. So, what are you going to do?

Plumbing problems, such as a leaking pipe, clogged drain, and, of course, a leaky faucet, can occur when you least expect it. As a result, knowing a bit or two about dealing with all of this comes in handy at times like this. The best part is that they aren’t tough at all!

Let me tell you four things you need to know in order to rescue the day.

Replacing a leaking shower head

It’s not as difficult as it sounds to replace an old, leaking shower head. Simply unscrew the screw, discard the old head, and replace it with the new one. Also, use a wrench to tighten the closure. That’s all there is to it!

However, if you do this and it doesn’t work, you may need to hire a plumber. Expert plumbers in Sutherland shire suggest it may be beyond just the showerhead.

Repairing a dripping faucet

The dripping sound of a leaky faucet, whether in the kitchen or bathroom, can be aggravating, not to mention the price to cover the waste. To begin, switch off the water supply from beneath the sink (if yours has both hot and cold supplies, turn them off). You’d need pipe and hex wrenches, as well as a fresh set of washers. On YouTube, you may get a step-by-step guide.

Clear the drain

Your tub’s drain could be clogged with something that is preventing the water from draining. Things are not too difficult to get it working again. You might try 15 minutes of baking soda and warm water. By then, any impediment should have been removed. Check to see whether it flows nicely.

You might also use a plunger/auger to force the obstruction out. If everything else fails, call your plumber!

Repairing leaking pipes

Begin by determining the source of the leak, as it may be hidden behind walls or in pipes that are not visible to you. Once you’ve found the leak, close the main supply valve and get to work. Epoxy putty can be used in conjunction with clamps and old bicycle rubber tubes. If the leak is not severe, duct tape can be used to close it off.

It’s not always a bad idea to try some of these on your own. However, you should also know when to seek assistance. So, learn these 4 fixes and keep them close at hand. You never know when you’re going to need them.

Show More

Related Articles

Back to top button